Installation Guide

4
755172-100
5
A) Apply a bead of tub surround adhesive down
each stud that will come in contact with the
side panels being sure to stay below the line
previously marked.
B) Lay a bead of sealant along side panel mating
surface and seated shower base ledge.
C) Align the top nailing flange of each side
panel with pencil line marked. Press firmly
into place to ensure proper adhesion to studs.
Check alignment with all mating surfaces and
reposition if necessary.
D) Locate and drill a clearance hole in the center of the
top nailing flange and centered on each stud (see
arrows as shown).
Also drill clearance holes in the front nailing flange
on each side panel at approx. 12" intervals, centered
on the flange (see arrows as shown).
Install galvanized screws through each hole and into
the studs, securing the wall panel.
SEALANT
(side panel
mating surface)
PENCIL LINE
TUB
SURROUND
ADHESIVE
(STUDS)
SEALANT
(SHOWER
EDGE)
DRILL CLEARANCE
HOLES FOR SCREWS