Warranty

Page 1
7302106-100 Rev. D 7/15
3
2
4 5
Side view of the toilet seat installation parts.
The hinge cap covers are designed to snap
lock on to the hinge. Position the hinge
covers and push down on the cover.
With the plastic bolts installed, thread the
winged plastic nuts on to the bolts.
When the seat is properly
aligned with the front edge
of the bowl shlip the bolt
through the washer and the
bowl bolt holes.
6
Tighten the bolts using a screwdriver.
Hinge
Cover
Hinge
Plastic
Bolt
Plastic
Wing Nut
Under Hinge
Base
Hinge
Gasket
Slot
Alignment
Tab
Hinge
Gasket
Adjustment
Washer
1
Attach Hinge Gaskets to bottom of Hinge Base.
Make sure Alignment Tabs on Hinge Gaskets
match the slots under the Hinge Base.
The installation kit includes two
sets of stainless washers:
2 with center holes and 2 with
offset holes.
The offset washers hole can be
set forward or back allowing the
seat to be moved back from or to
the forward edge of the bowl rim.
Align hinges over holes on toilet bowl.
FRONT OF BOWL
TANK
To Move
Seat Forward
To Move
Seat Back
INSTALLATION #1 - BOTTOM MOUNT WITH PLASTIC WINGNUT