Installation Sheet

NUT
WASHER
WASHER
GARBAGE DISPOSAL RIM & STOPPER
INSTALLATION INSTRUCTIONS
SOAP DISPENSER
INSTALLATION INSTRUCTIONS
1. Either use an existing hole in the sink, lavatory or countertop or prepare one
specially. It should have diameter between 1" and 1-1/2". The maximum
thickness of the fixture should not exceed 1-1/2".
2. Pass the PUMP HOLDER down through the hole from above with the WASHER
immediately above the fixture. From below install the WASHER onto the PUMP
HOLDER and screw the NUT onto the PUMP HOLDER.
3. Screw the BOTTLE onto the lower end of the PUMP HOLDER.
4. The PUMP UNIT will already be assembled within the HEAD. Push the TUBE
into the lower end of the PUMP.
5. Fill the BOTTLE through the top of the PUMP HOLDER. The BOTTLE holds
15 Fl. oz. and should not be over filled. Then place the assembled HEAD, PUMP
UNIT and TUBE into the PUMP HOLDER.
1. Push rim into sink drain until rim is seated flush
against sink drain.
2. Insert Stopper into Rim.
STOPPER
RIM
SINK DRAIN
DISPOSER
PUMP
HOLDER
BOTTLE
PUMP
UNIT
PUMP
UNIT