Installation Guide

7302165-100 Rev. A

- 4 -

WARNING: Overtightening of water supply line nuts could result in breakage and potential flooding. If the

connection leaks after hand tightening, replace the supply line. Do not use any type of sealant on the water

supply connection. Use of plumber’s putty, pipe dope, or any other type of sealant will void the warranty.

ACTUATOR

HOSE LOCK

COLLARS

AA BATTERY PACK

AIR HOSE

ACTUATOR FACE

POWER ICON

MANUAL FLUSH BUTTON

FILL VALVE

WATER LEVEL ADJUSTMENT KNOB*

*See Step 1 of “TO OPERATE TOILET” of

“OPERATIONAL GUIDE” below.

OPERATIONAL GUIDE

Adjust water level to the water level

line indicated on the back of the tank.

FLUSH VALVE TOWER

TO INSTALL BATTERIES

(4) AA Batteries ONLY

(DO NOT USE 9 VOLT)

TO OPERATE TOILET

TO OPERATE ON/OFF FEATURE

On/Off feature puts the sensor into an off mode for 10

minutes, allowing time to clean in the bathroom area

without constantly flushing the touchless toilet.

Step 1) Lift open rubber battery housing cover, remove battery tray and install 4 alkaline AA

batteries into the battery tray.

Step 2) Insert battery tray back into the battery housing and connect sensor plug to battery tray.

Sensor will flash red once followed by 3 consecutive blue flashes.

Step 3) Route wires through slot in battery housing and close battery housing cover making sure it is

secure to prevent corrosion.

Step 1) Turn on water supply. Adjust water level to water level line indicated on the back of the tank by

turning Water Level Adjustment Knob on fill valve to move float cup up or down. Turning

knob clockwise raises water level. Turning knob counterclockwise lowers water level.

It is critical that water be filled exactly to specified water level for optimum performance.

Step 2) To flush toilet, swipe hand within 3 inches of activation sensor on side of toilet. Sensor will flash

blue twice.

Step 1) Feature is activated by touching the Power Icon for 3-6 seconds. Sensor will flash blue twice

and then constantly flash red while in this mode.

Step 2) Exit off mode by touching the Power Icon for 3-6 seconds. Sensor will flash blue 4 times.