Installation Guide

C/L of 2x6" or 2x4"

(51x152mm or 51x102mm)

Wood Reinforcement

Finished

Floor

770250-100

- 3 -

FURNITURE INSTALLATION STEPS:

Assemble two drawer pulls to vanity using supplied M5 x 25 screw mounting kit 770251-100 or assemble towel bar to washstand using

supplied M8 x 25 screw mounting kit 770252-200 (Figure 1). Note that the drawer pulls and towel bar are required accessories that are

purchased separate from the furniture itself.

Prepare the wall to safely secure the furniture in place. Provide suitable reinforcement behind the ﬁnished wall. Centerline of

reinforcement should be 31" (787mm) from the ﬂoor (Figure 2).

Level furniture by adjusting each of the four 770253-200 leveling feet (Figure 3). Four leveling feet are included with the furniture purchase.

Drill at least two 3/8" (10mm) diameter anchoring holes through the centerline of the rear stringer of the furniture and attach furniture to

wall with wood screws not included with furniture. Per step 2 detail, the screws shall be inserted into suitable reinforcement within the

wall. Anchor the furniture to the wall through at least two of the anchoring holes in the rear of the furniture.

Install the Townsend sink top to the furniture. Refer to the appropriate sink installation instructions for sink details. Note that one of the

top options shown on the previous pages are required and are purchased separate from the furniture itself.

Apply a 1/8" (3mm) thick bead of water-based caulk around the top edge of the furniture (Figure 4) and place top on furniture. Refer to

the ﬁrst page regarding caulk type. Allow caulk to dry before proceeding.

Purchase and install the appropriate faucet and drain according to the maufacturer’s instructions.

RECOMMENDED CARE AND CLEANING OF AMERICAN STANDARD FURNITURE:

Clean the furniture and quartz tops using soft, slightly damp cloth. Buff the product by using a soft dry cloth.

Avoid using silicone cleaners and waxes. Clean up excess water and spills immediately and use a blotting rather than a

wiping action. Water left over a long period of time will cause white spots in the ﬁnish.

NOTE: Some chemicals may damage the product ﬁnishes. Take care to avoid the following: iodine, hair dye, after shave

lotion, shaving cream, alcohol, perfume, Lestoil

, Lysol Tub and Tile Cleaner

, Lysol Spray Disinfectant

, Dow Disinfectant

acetone, paint remover, Formula 409

, Tile-X

and Nair

Towel bar kit 770252-100 (2 screws)

FIGURE 1 FIGURE 2

Drawer pull kit 770251-100 (4 screws)

Leveling foot 770253-200

Apply

sealant

Apply

sealant

Apply

sealant

FIGURE 3 FIGURE 4

31"

(787 mm)