Installation Guide

INSTALLATION
Preparing for Installation
3
Warning: Inspect all items for defects and/or breakage. If significant damage is presnet do not install
product and contact customer service.
Prior to installation, measurements of the outer dimesions of the Seated Shower should be taken
Demensions should be written here, ________ L x ________ W, for later reference.
Installation
If the shower enclosure is not already standing, a three wall frame should be built based off the
dimensions of the Seated Shower, as shown below in figure 1.
After frame has been built the Seated Shower should be test fitted in place. There should be no
more than a 1/4” gap between outer Seated Shower wall and wood frame.
Note: A Drain Trough may need to be cut into the floor in order to accomodate drain plumbing.
It should be 12” W x 16” L.
Figure 1
Three Wall Wood Frame
Drain Trough
12”W x 16”L
Thank you for purchasing the American Standard Seated Shower Base. Please read all instructions carefully
prior to installing the Seated Shower. This manual will serve as a guide to get your seated shower installed
properly and safely. If you have any questions, please contact your local distributor or contact customer
service for additional assistance.