Specifications

7
10) Trim the liner to ¾” stick out from the end of the gooseneck.
11) Replace the Diffuser, contact tip and nozzle.
12) Feed welding wire into the torch and tighten drive rolls.
WARNING: WHEN FEEDING WELD WIRE THROUGH THE TORCH KEEP THE FRONT END OF THE TORCH POINTED AWAY FROM
ANY PERSON OR OBJECT. DO NOT POINT AT FACE, HANDS ETC. FAILURE TO DO SO WILL RESULT IN BODILY INJURY AND
POSSIBLY DEATH.
Gooseneck Replacement
1) Secure Gooseneck in a vice.
2) Remove the liner from the torch.
3) Remove the four handle screws and separate the handle assembly.
4) Using a wrench loosen the gooseneck / cable connection and remove from the cable assembly.
5) Remove the Body Insulator from the old gooseneck and install on the new one.
6) Thread the new gooseneck on to the cable assembly and tighten.
7) Install the bottom handle assembly (trigger side) onto the gooseneck/cable assembly. The trigger wires will fit in the
grooves on the sides of the body insulator. Make sure the trigger wires stay seating in the body insulator and the
insulator is fully inserted into the bottom handle.
8) Slide the handle spring or cable support up and insert in the rear of the handle.
9) Install the top handle and secure with the (4) screws. IMPORTANT: Insure the trigger wires are not pinched between
the handle.
10) Reinstall the diffuser, contact tip and nozzle.
Unicable Replacement
1) Secure Gooseneck in a vice.
2) Remove the liner from the torch.
3) Remove the four handle screws and separate the handle assembly.
4) Using a wrench loosen the gooseneck / cable connection and remove from the cable assembly.
5) Thread the gooseneck on to the new cable assembly and tighten.
6) Install the bottom handle assembly (trigger side) onto the gooseneck/cable assembly. The trigger wires will fit in the
grooves on the sides of the body insulator. Make sure the trigger wires stay seating in the body insulator and the
insulator is fully inserted into the bottom handle.
7) Slide the handle spring or cable support up and insert in the rear of the handle.
8) Install the top handle and secure with the (4) screws. IMPORTANT: Insure the trigger wires are not pinched between
the handle.
9) Reinstall the diffuser, contact tip and nozzle.
10) On the rear of the old cable assembly turn and remove the spring guard hand nut and slide back on the cable.
11) Remove the screw securing the handle to the feeder pin adaptor and separate the handle.
12) Unthread the power cable from the feeder adaptor block.
13) Slide the threaded rear handle support nut and rear spring onto the new cable assembly.
14) Thread the power cable to the feeder pin adaptor and tighten.
15) Install the trigger wire using (2) butt splices.
16) Install the bottom handle assembly onto the feeder adaptor assembly.
17) Carefully route the trigger lead thru the opening in the handle half. Make sure the trigger wires are not pinched
between the handle halves.
18) Install the other handle half and screw the rear handle support nut and rear spring on the rear handle assembly.
19) Install the screw on the rear handle and feeder adaptor.
20) Reinstall the liner.
DAILY MAINTENANCE
A few minutes per day performing a quick check of your mig torch will help to decrease weld problems, minimize downtime,
and help increase consumable life.
At Beginning of Shift