Specifications

6
Using Feeder Adaptor Kit
In some cases it may be desirable to use a feeder adaptor kit such as when using different manufactures wire feed units to
commonize on a torch configuration.
1) Thread feeder adaptor plug into the adaptor block and tighten.
2) Insert the adaptor guide tube into the adaptor plug.
3) Fully insert the feeder adaptor assembly into the wire feeder. Tighten screw or other method on wire feeder to
secure the adaptor assembly.
4) If required, connect the feeder control cable/plug to the wiring on the adaptor assembly.
5) Connect feeder control cable/plug to the feeder.
6) Connect the torch to the feeder adaptor assembly.
7) Feed welding wire into the torch and tighten drive rolls.
WARNING: WHEN FEEDING WELD WIRE THROUGH THE TORCH KEEP THE FRONT END OF THE TORCH POINTED AWAY FROM
ANY PERSON OR OBJECT. DO NOT POINT AT FACE, HANDS ETC. FAILURE TO DO SO WILL RESULT IN BODILY INJURY AND
POSSIBLY DEATH.
Torch Mount Installation
The robotic torch has a precious locating flat for accurate locating in the mating torch mount.
1) Loosen the cap screw in the torch mount.
2) Insert the torch through the top of the mount lining the locating flat on the torch with the mating flat on the torch
mount.
3) Fully insert the torch into the torch mount.
4) Tighten the cap screw to secure the torch into the torch mounting arm.
MAINTENANCE
Liner Replacement
There are two types of liners offered – standard and the EASY front loading liner system. The standard liner requires the torch
be removed from the feeder in order to be changed. The EASY front load system only requires the removal of the front end
consumables.
Standard Liner Maintenance
Warnings – To avoid accidental injury ensure power supply and wire feed unit is turned off.
1) Trim the end of the weld wire at contact tip.
2) Retract or completely remove weld wire so torch can be removed from the wire feeder.
3) Remove the nozzle, contact tip and diffuser.
4) Loosen the set screw at the torch feeder connection using a 5/64” Allen wrench.
5) Making sure the torch cable is straight, grasp the liner at the rear of the torch with a pair of pliers and remove.
6) Carefully feed the new liner into the torch using short strokes to avoid kinking. You may need to twist the liner for
easier insertion.
7) Tighten the set screw to secure the liner in the torch.
8) Reinstall the torch to the wire feed unit.
9) IMPORTANT: at the front end of the torch push the liner back into the gun and hold in place.