Specifications
2
TABLE OF CONTENTS
INTRODUCTION/WARRANTY ....................................................................................................................................... 2
GENERAL SAFETY ...................................................................................................................................................... 3
TORCH SPECIFICATIONS ............................................................................................................................................. 3
NOZZLE/TIP RELATIONSHIPS ....................................................................................................................................... 4
INSTALLATION .......................................................................................................................................................... 4
LINER REPLACEMENT ................................................................................................................................................ 4
GOOSENECK REPLACEMENT ........................................................................................................................................ 6
UNICABLE REPLACEMENT ........................................................................................................................................... 6
DAILY MAINTENANCE................................................................................................................................................ 7
NOZZLE SELECTION CHART ......................................................................................................................................................... 8
CONTACT TIP SELLECTION CHART ................................................................................................................................ 9
PARTS BREAKDOWN .......................................................................................................................................... 10-11
INTRODUCTION
Thank you for purchasing an American Weldquip product. The American Weldquip product you have purchased has been
carefully manufactured, assembled, and fully tested. This manual contains information on the installation, operation,
maintenance, and replacement part breakdown. Please read, understand, and follow all safety instructions, warnings and
procedures. Keep this manual handy for referencing installation, operation, maintenance, and part ordering information. While
every precaution has been taken as to the accuracy in this manual, American Weldquip, Inc. assumes no responsibility for errors
or omissions. American Weldquip, Inc. assumes no liability for damages resulting from the use of the information contained in
this manual. American Weldquip, Inc. shall have no liability to the buyer for consequential damages or expenses by any defect
whatsoever.
WARRANTY
AMERICAN WELDQUIP MIG guns and parts are warranted to be free of defects in material and/or workmanship for the period
of time listed below. For any product found to be defective under normal use, AMERICAN WELDQUIP, INC. at our option, will
repair, replace or issue a credit for the value of the defective product. All warranty claims must be submitted by the original
purchaser. Use of non-genuine AMERICAN WELDQUIP parts and/or consumables may damage and/or severely limit the
performance of the equipment which may limit or void any warranties. AMERICAN WELDQUIP, INC. will not assume
responsibility for incidental damages or expenses related to any defect. This warranty does not cover damage caused by misuse
or abuse, accident, alteration of product, improper installation, misapplication, lack of reasonable care and maintenance,
unauthorized repairs or modifications, loss of use while at a repair facility or other conditions that are beyond the control of
American Weldquip, Inc.
A Return Authorization Number (RA#) must be attained from the factory for any product being returned for Warranty Repair or
Replacement. All returned product must be shipped freight prepaid by the sender. No- charge replacements, repaired
products, or credit will be issued, once the returned product has been evaluated and warranty condition has been verified. If an
immediate replacement is required before proper warranty evaluation, a purchase order number is required and the goods will
be invoiced. A credit will be issued once it is determined that a warranty condition exists.
STANDARD WARRANTY
All Semi-Automatic, Automatic, Robotic MIG TORCHES and Components = 120 Days
MIG Torch Trigger Switches (Contacts only) -Excludes Smoke Extraction = LIFETIME
Robotic Nozzle Cleaning Stations, Wire Cutter = 90 Days
Robotic Peripherals, ArcSafe, Gun Mounts = 90 Days
TIG POINT Tungsten Electrode Grinders = 90 Days