Installation Guide

3
4
DRY FITTING SIDE WALLS
DRY FITTING REAR WALL
3a. Place Side Wall into position in the alcove until corner is correctly in place, fitting squarely on top of
shower base or tub with approximately a 1/8" gap. TIP: Can use paint mixing paddle as spacers for this.
Check the vertical edges of the panel with a level that they are plumb.
3b. Starting with the Side Panel plumbed for fittings, mark all plumbing locations where shower valves or
shower heads come through the Side Panel. Place tape over the area to be drilled to protect panel
surface finish and drill holes at each location using hole saws large enough to accommodate the opening
but small enough to be covered by the trim plates.
3c. Once correctly in position and plumb, drill 11/64" pilot holes in the top flange and use 1 or 2 screws to
temporally hold the wall panel in place. TIP: After drilling clearance hole through the wall flange drill a
pilot hole for wood screw. This will prevent the screw from following wood grain and pulling wall out of
alignment. Leave the corner of the Wall Panel free floating for the next steps. Dry fit the second Side Wall
Panel in the same manner.
Once both Left & Right Side Wall Panels are correctly
dry fitted, the Rear Wall Panel can be dry fitted.
NOTE: Long Extrusions will not be installed until
after trial/dry fit.
TOP FLANGE
PROVIDE A 1/8"
GAP BETWEEN
DECK OF TUB/BASE.
TILE FLANGE
ALCOVE
FRAMING
WALL
POCKET
1X4
ILLUSTRATION
SHOWN USING TUB
4a. Place the Rear Wall Panel between the Left and
Right Side Panels. Check that there is no gap
between the Rear and Side Wall Panels. If there
is a gap between either Side Wall Panel and the
Rear Wall Panel or the Rear Wall Panel does not
fit between the Side Wall Panels, it will be neces-
sary to re-adjust the Side Panel(s) to ensure the
proper fit.
NOTE: Add shims behind panel flange if neces-
sary to fill in any gaps or spaces. Prepare
shims as needed for the Side Walls to be
used for final installation.
PROVIDE A 1/8"
GAP BETWEEN
DECK OF TUB/BASE.
APPROXIMATE SHIM LOCATIONS
ILLUSTRATION
SHOWN USING TUB