Specification Sheet

HOT
FIGURE 1.
Determine the distance from the finished wall to the center of the floor
water supply holes and mark a centerline.
Note: Check that floor is level in both directions.
Drill a 2" (51mm) diameter hole for the 1/2" Hot and Cold supplies.
Slide MOUNTING FLANGE (1) downwards on the TUB FILLER ASSEMBLY (2).
Place MOUNTING FLANGE (1) over the floor supply hole.
Align and center the TUB FILLER ASSEMBLY (2).
FIGURE 2.
With the TUB FILLER ASSEMBLY (2) aligned and in desired
position, mark on the floor the four mounting holes for the
MOUNTING FLANGE (1).
DETERMINE MOUNTING LOCATION
3
FIGURE 3.
Drill four 1/4" (6mm) diameter holes 1-3/4" (44mm) deep.
Install the four ANCHORS (4) supplied, flush with the top of the
finished floor.
1
2
2
1
4
Level
BASE BOARD
(1) 2" (51mm)
DIA. HOLE
FINISHED WALL LINE
FIGURE 1
FIGURE 2
FIGURE 3
M 9 6 5 14 0 R E V. 1. 3
3