Installation Guide

2
INSTALLATION INSTRUCTIONS:
A.) Set up the cover in the desired location. Locate the drain outlet location
and supply line locations for the faucet (see faucet instructions).
B.) Recommend cutting floor cutout - 10" x 5-5/8" (254mm x 143mm)
use cover as guide, as shown above.
C.) Mark lines on the floor for the cover location.
Use these to relocate cover.
D.) Turn the cover over and apply silicone caulking
to the bottom of the cover as shown.
1
A.) Set cover down in place and secure to the floor with 6 screws (not provided)
through wood strip locations.
B.) Apply foam tape to outside top edge, even with the top edge.
Trim away excess gasket.
2
SCREW HERE
FOAM
3
A.) Apply silicone caulk to the bottom of tub as shown.
B.) Place tub into cover. Make sure to evenly center the tub onto the cover.
The gasket will be compressed between the tub and cover.
A.) Assemble drain to tub per drain instructions.
4
754782-100 Rev. C