Specification

H44
TOWN SQUARE
®
6' x 42"
ECOSILENT
™
COMBO MASSAGE BATH
HIGH GLOSS
NOTES:
BATH CAN BE INSTALLED EITHER ABOVE OR BELOW FLOOR LINE AS PIER, ISLAND OR PENINSULA TYPE INSTALLATION. SUMP OF BATH
IS SUPPORTED BY INTEGRAL FEET. NO ADDITIONAL SUPPORT REQUIRED. ENCLOSING MATERIALS BY OTHERS.
● IF INSTALLING A DECK-MOUNTED FITTING, BEFORE DRILLING ANY HOLES: CHECK FOR INTERFERENCE WITH CIRCULATING SYSTEM
PIPING AND DRAIN OVERFLOW. MOUNTING HOLES DRILLED BY INSTALLER.
■ REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH BATH FOR ADDITIONAL INFORMATION.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL SUPPORTS.
IMPORTANT: Dimensions of xtures are nominal and may vary within the range of tolerances established by ANSI Standard Z124.1 / CSA Certied.
These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided leaet.
CONTROL
PANELS
41-3/4"
(1060mm)
26-3/4"
(679mm)
7-3/4" TYPICAL
(197mm)
35-3/4"
(908mm)
13-1/4"
(337mm)
71-1/2"
(1816mm)
3"
(76mm)
FLOOR CUTOUT
9" X 19"
(229 X 459mm)
OUTLINE OF CUTOUT
70" X 40-1/4" (1778 X 1022mm)
INTEGRAL
FITTING DECK
3" X 14"
(76 X 356mm)
3/4"
(19mm)
EDGE OF
FLOOR
CUTOUT
AIR
BLOWER
LEVELING STRINGER
(NOT FOR SUPPORT)
2"
(51mm)
3-1/4"
(83mm)
20"
(508mm)
22"
(559mm)
ROUGH
FLOOR
10-1/4"
(260mm)
INTEGRAL FEET WITH
ATTACHED BASEBOARD
8 WHIRLPOOL
JETS
ACCESS AIR BLOWER, PUMP
MOTOR, WHIRLPOOL HEATER
AND LIGHTING SYSTEM AT
THIS END OF TUB
NOTE:
INSTALLER MUST PROVIDE 12" X 24" ACCESS OPENING FOR SERVICING AIR
BLOWER, PUMP MOTOR, WHIRLPOOL HEATER, AND LIGHTING SYSTEM.
THIS MODEL INCLUDES A DRAIN ASSEMBLY. OTHER DRAIN ASSEMBLIES
CANNOT BE USED. REVIEW DRAIN INSTALLATION DETAILS IN THE DOCUMENT
TO FULLY UNDERSTAND FLOOR CUTOUT REQUIREMENTS.
GENERAL SPECIFICATIONS FOR 2742
COMBINATION SYSTEM
71-1/2 x 41-3/4 x 22 In. (1816 x 1060 x 559mm)
174 Lbs. (79 Kg.)
830 Lbs. (313 Kg.)
69 Gal. (261 L)
41 x 21-1/2 In. (1041 x 546mm)
62 x 31-1/2 In. (1574 x 800mm)
14-1/4 In. (362mm)
36 Lbs./Sq.Ft. (176 Kgs./Sq.m)
27.8
55.7
ELECTRICAL SPECIFICATIONS
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
PTS.
CUBE (FT
3
)
© 2010 AS America Inc.
Revised 6/10
NOTE: See installation instructions for electrical specications