Specifications

TOOLS REQUIRED; Fig. 2
Fig. 2
Fig. 1
1 Channel Locks
2 Adjustable Wrench
3 Plumbers' Putty or Caulking
4 Phillips Screwdriver
5 Flat Blade Screwdriver
6 Electric Drill & 1/4" Drill Bit
7 Tape Measure
1
2
3
4
5
6
7
Roughing-in Dimensions
10'
2
114mm
(4-1/2)
500mm
(20)
381mm
(15)
3/8" COMP.
32mm (1-1/4)
55.5mm
(2-3/16)
125mm
(4-7/8)
81mm
(3-3/16)
49mm
(2)
GENERAL DESCRIPTION:
Electronic faucet with proximity operation. Vandal
resistant solid brass construction single post
mounting. Operates on AC permanent power. Water
pressure range from 20 to 125 psi. In-line strainer
for solenoid is integral. Single inlet 3/8 compression,
built-in checks, and flexible stainless steel 15" reach
inlet hose for spout connection.
159mm
(6-1/4)
126mm
(5)
154mm
(6-1/16)
FINISHED
WALL
CODES AND STANDARDS:
These products meet or exceed the following
coded standards:
ANSI A117.1
ASME A112.18.1
CSA B 125
NSF 61/Section 9
ADA Compliant
M965274 REV. 1.2
ELECTRICAL BOX
OR EQUIVALENT
BY OTHERS
Note: All plumbing and electrical wiring must be
installed in accordance with applicable codes,
regulations and standards.
Fig. 1a
1
4
6
5
3
2
INSTALLATION
INSTALL SPOUT ASSEMBLY;
Fig. 1
CAUTION
Turn off hot and cold water
supplies before beginning
1
1. Connect the two 27" EXTENSION CABLES (1) to
the Faucet Sensor Cables. Fig. 1.
2. Insert EXTENSION CABLES (1), FLEX HOSE (2)
and SPOUT SHANK (3) through center hole of
mounting surface. Fig. 1.
3. Assemble "C" WASHER (4), STAR WASHER (5)
and LOCKNUT (6) onto threads of SPOUT SHANK (7)
from underside of mounting surface. Fig. 1a.
4. Align FAUCET and tighten LOCKNUT (6). Fig. 1a.
7
Fig. 1
SENSOR
CABLES
1
CAUTION: Use only American Standard
supplied cable sets. Using non-AS supplied
cables, or cutting, splicing or modifying any
components will void the warranty.