Installation & Assembly

5
!
M965612 Rev. 1.5 (8/15)
ELECTRICAL INSTALLATION
Fig. 1a
Fig. 1b
Fig. 1
Fig. 1c
5a
7
2
Fig. 1d
2
3
1
4
5
INSTALL BATTERY
STANDARD
BATTERY
STANDARD
BATTERY
LONG LIFE
POWER PACK
LONG LIFE
POWER PACK
CR-P2
5a
5a
5a
6
5
Product Page
DC Long Life Power Pack
(2064.142 /.145)
4
DC Standard Battery (2064.153 /.155)
4
AC Plug-in (2064.162 /.165)
5
AC Hardwire(2064.192 /.195)
5
AC Multi Hook-up(2064.172 /.175)
6
A
DC VERSIONS (LONG LIFE POWER
PACK & STANDARD BATTERY);
Fig. 1
1. Remove CONTROL BOX COVER (1). Fig. 1.
2. Feed the SENSOR CABLES (2) through the top of
CONTROL BOX (3). Fig. 1a.
3. Insert BATTERY (4) into BATTERY HOLDER (5), make
sure the shape of the BATTERY (4) follows the shape
of the BATTERY HOLDER (5) and terminal end is
inserted rst. Fig. 1b.
4. Insert the BATTERY CONNECTOR (5a) for the
Standard Battery or Long Life Power Pack through
side GROMMET (6) as shown. Fig. 1c.
Prior to making power connection, make sure detection
zone is not obstructed. Sensor is self adjusting. Keep
detection zone clear for 15 seconds after power is
connected.
5. Connect SOLENOID CABLE (7) and BATTERY
CONNECTOR (5a) to SENSOR CABLES (2).
Place Standard Battery or Long Life Power pack into
Housing. Fig. 1d.
6. Replace CONTROL BOX COVER (1). Tighten cover
screws rmly.
CAUTION: Use only American Standard supplied
transformers and cable sets. Using non-AS supplied
cables, or cutting, splicing or modifying any components
will void the warranty.