Installation & Assembly

791640-100 Rev. A 11/17
- 3 -
A
B
Single Bowl
Double Bowl
Tra p
Tra p
Connect drain assembly hand tight to check alignment. It may be
necessary to cut off part of the tailpiece (area "A") or part of the
horizontal leg of the trap (area "B").
Secure joint for watertight assembly.
8
7
Connect supply lines to faucet finger tight, and
carefully bend to engage with the supply stops.
Tighten connections to faucet for secure seal.
A. Carefully lower sink into cutout. Make sure the sink is in the proper
location and press down firmly.
WARNING: Improper tightening of screws could result in
improper installation or cause damage to the sink.
B. Loosen the screw and turn the clamp 90 degrees so the clamp can
catch the bottom of countertop as shown. Hand tighten the screws.
C. Recheck sink position on countertop. Tighten all screws an
additional 1/4 turn with a flat head screwdriver.
WARNING: DO NOT OVERTIGHTEN
6
!
!
Assemble the screw with the clamp as shown (1).
Slide the screw and clamp assembly under the open end of
the U Channel as the location on the template suggests.
Turn the clamp in the same direction as the U Channel and
hand tighten the screw as shown (2).
5
Screw
U Channel
Clamp Clamp
(1) (2)
Slide Screw
with Clamp
into U Channel
For Sinks with Mounting Brackets Attached to Sink
Place notched end of the screw into the keyhole slot in
sink bracket. Use one screw per double bracket. Turn
clamp to rest against side of sink.
For Sinks with Mounting Brackets Attached to Sink
Turn the clamp 90 degrees so they grasp the underside of the
countertop. Tighten the clamps gradually, only until sink rim is
ush with countertop. Do not over tighten as damage can result.
Clamp
Screw
Bracket
SINK
COUNTERTOP
Screw
Clamp
Bracket
COUNTERTOP
SINK
Screw
Screwdriver
U Channel
Clamp
COUNTERTOP
SINK