Installation Instructions

pg9
Control Panel Operation and Indicators
Cleaning Cycles
Quick Clean
Quick Clean is best used for regular upkeep, in between deep cleanings. A Quick Clean cycle will
clean the inside of the toilet bowl in just one minute. We recommend using the quick clean cycle
1 time per week.
Deep Clean
Deep Clean is used for more thorough cleanings. It releases more cleaning fluid and the cycle is
longer compared to a Quick Clean cycle. A Deep Clean cycle completely and thoroughly cleans
the inside of the toilet bowl in 10 minutes. The result is a fresh scented, sparkling clean bowl! We
recommend a deep cleaning 1 time per week.
Low Reminder
Order Cartridge
Replace Batteries
4 AA Required
Deep Clean
10 Minute Cycle
Quick Clean
1 Minute Cycle
To Install New Toilet Cleaning Cartridge:
1 - Remove the child resistant safety cap from the cartridge
2 - Insert the cartridge straight down until it snaps into place
3 - Press and hold either the QUICK or DEEP icon for three
seconds until the LOW level indicator light goes o
4 - Repeat steps 1 through 4 every time a new cartridge is
inserted to ensure proper operation
To Remove Empty Toilet Cleaning Cartridge:
- The cartridge will need to be replaced shortly after
the “LOW” icon is displayed
- Pull upward firmly to remove the empty cartridge
We encourage that you please recycle empty cartridges
To Activate Cleaning Cycle:
- Check bowl for debris and if necessary flush the toilet
- After flushing wait 30 seconds
- Open the control panel door to power the ActiClean™ system
- Select from either QUICK or DEEP cleaning cycles
Note if the selection is not made within 30 seconds the system will go to sleep
To Cancel a Cleaning Cycle:
- Push the QUICK or DEEP cleaning cycle icon a second time
- The cycle will stop and rinse the bowl after 30 seconds
Child Lock:
- ON/OFF: Press and hold both QUICK and DEEP buttons for 3 seconds
ActiClean™ System Instructions