Installation Instructions

pg8

1 - Remove the child resistant safety cap from the cartridge

2 - Insert the cartridge straight down until it snaps into place

3 - Press and hold either the QUICK or DEEP icon for three

seconds until the LOW level indicator light goes off

4 - Repeat steps 1 through 4 every time a new cartridge is

inserted to ensure proper operation

INSTALLING BATTERIES

Push tab on the Battery Compartment Cover (D) to open the

Battery Compartment (B).

Place 4 AA Alkaline batteries (C) inside the Battery Compartment

then secure the cover to the Battery Compartment (B).

(A)

(D)

(C)

(B)

LOCK AND UNLOCK POSITIONS

LOCKUNLOCK

If access to the internal tank components is needed, first turn the Locking

Knobs to the UNLOCK position. This will allow you to remove the Tank Top

and work on the tank trim if needed.

REMEMBER: Before operating the ActiClean system, you must always be

sure to turn the Locking Knobs to the LOCK position.

BEFORE INSTALLING THE CLEANING CARTRIDGE,

REMOVE CHILD RESISTANT CAP LOCATED ON THE

BOTTOM OF THE CLEANING CARTRIDGE

A. Open the lid.

B. The tank Locking Knobs should be set to the UNLOCK position to properly seat

the Tank Top in place. If they aren’t, turn them to UNLOCK position first.

C. Then to lock the Tank Top in place, turn the Locking Knobs to the Lock position.

This will ensure proper operation of the ActiClean cleaning cycles.

Toilet Cleaning

Cartridge (A)

Child Resistant Cap

INSTALLING TOILET CLEANING CARTRIDGE