Installation Instructions

pg6
10
Allow the tank to fill with water and
check that the water level matches
the indicated dimension. Reference
the barcode sticker inside the tank
on the back wall.
If the water level needs to be raised,
move the fine level adjustment up
one or two clicks.
If the water level needs to be lower,
please refer to the Troubleshooting
Guide on page 12.
A
C
Prime the system by flushing the
product 5 times before use to
achieve optimal performance.
B
PROPER FLUSHING METHOD:
Be sure to fully depress the handle
down with each flush. Do not hold
the handle down for extended
periods of time as this could allow
air to enter the system which will
slightly degrade performance for a
few flushes.
Water Supply Line
Set Approximate
Water Level
Fine Water Level
Adjustment
Inlet Valve
Lock
Tab
Barcode
Sticker
Top of Overflow
Turn on water supply. Allow tank to fill.
Connect water supply line. (Sold separately)
Hand tighten nut.
* For seat installation, see instructions included with seat.
9
A
B
Gasket
Nut
4515A
79
4.8 Lpf / 1.28 gpf
!
WARNING: Do not use plumber’s putty, pipe dope, or
any other sealant on the water supply connection to
this tank. If the connection leaks after hand tightening,
replace the supply line. If the connection continues to
leak with the new supply line, replace the inlet valve.
Warranty is void if any type of sealant is used on
the water supply connection.
!
WARNING: Overtightening of water supply
line nuts could result in breakage and
potential flooding. If the connection leaks
after hand tightening, replace the supply line.