Installation Instructions

NOTES:
a) To ease installation, push down on the top of the tank while tightening handles.
b) Tighten all three bolts adequately.
Secure tank to bowl with provided nuts using attachment handle supplied.
Tighten nuts alternately until the tank contacts the front and back of the
bowl achieving complete contact.
8
ATTACHMENT HANDLE WITH NUT
VERIFY ADJUSTABLE SCREW SETUP
1. Depress handle all the way (A).
2. With handle depressed, adjust screw (B) on the teeter bar so red rear frame (C)
slightly touches the black frame stop (D).
DO NOT OVERTIGHTEN SCREW (B) !
NOTE: Turning the adjustable screw counterclockwise will loosen and move red rear
frame (C) AWAY from black frame stop (D). Clockwise will tighten and move
red rear frame (C) CLOSER to black frame stop (D).
3. Return handle (A) to rest position.
4. Make sure hook (E) is fully engaged under tab on valve body (F). If not engaged properly
repeat Step 2.
(A)
7
pg5
!
BLACK
FLAPPER
BLACK FRAME
STOP (D)
BLACK FRAME
STOP (D)
RED REAR
FRAME (C)
RED REAR
FRAME (C)
ADJUSTABLE
SCREW (B)
RED
FLAPPER
HOOK (E)
NOT
FULLY
ENGAGED
HOOK (E)
VALVE BODY (F)
VALVE BODY (F)
HOOK (E)
FULLY
ENGAGED
RED REAR FRAME (C)
SHOWN IN THE OPEN
POSITION SLIGHTLY
TOUCHING THE BLACK
FRAME STOP (D).