Installation Instructions

Flip the bowl upside down
and press the wax ring
down firmly .
1
Align the bowl and bolt
holes to set into place.
Apply weight evenly.
Do not move after
placement as water
tight seal may break.
TIP: Place a piece of
masking tape on the
floor next to the bolts
on both sides to help
with alignment.
Install T-Bolts onto the flange
and screw the retaining nuts
to hold into place.
3
Flip the tank over to confirm
gaskets are fully seated on tank.
Remove all packaging.
4
4
2
6
5
!
Hand tighten
only. Do not
overtighten.
BOLT CAP
BOWL-TO-FLOOR
KNOBS
GASKETS
DO NOT REMOVE FACTORY
INSTALLED NUTS
!
pg4