Installation Guide

M968492 Rev.1.4
3a
VALVE ASSEMBLY (1340.725)
For Cold or Tempered Water Supply
5
4
12
13
6
7
2
4
5/16'' MIN.
MOUNTING
SURFACE
8
9
1
3
9
MOUNTING
SURFACE
8
COLD OR
TEMPERED
WATER
11
10
7
1/2" IPS FLEXIBLE SUPPLIES or
3/8" O.D. BULL-NOSE RISER
COUPLING NUT
Valve assembly is same as two handle lavatory faucets. See Step 3
instructions for assembly, (1340.725 Single Valve Faucet) is for Cold
or Tempered water only.
14
Turn off hot and cold water
supplies before beginning.
CAUTION
4
Assemble RUBBER WASHER (5) and BRASS WASHER (6) and
LOCKNUT (7) onto SPOUT SHANK (4). Align SPOUT ASSEMBLY.
From underside of ledge, tighten LOCKNUT (7) approximately
halfway up the spout shank.
Press SPOUT SHANK (4) onto TEE (8) making certain that the
O-RING (3) is properly seated on SHANK (4). Push COUPLING (9)
into TEE (8) and attach to SPOUT SHANK (4) and tighten.
Por la parte inferior, apriete la tuerca (7) para asequrar el
cuerpo a la superficie de montaje.
SPOUT ASSEMBLY
Install RING WASHER (1) into SPOUT (2) recess. Check
that O-RING (3) on end of SPOUT SHANK (4) is in place. Insert
SPOUT SHANK (4) into center hole on mounting surface.
SPOUT
RECESS
1
3
2
8
MOUNTING
SURFACE
SPOUT
ASSEMBLY
4
COLD
HOT
9
5
6
7