Installation Guide

3
770279-100 Rev. 1 05/2020
Connect trap to drain assembly hand tight to check alignment. It
may be necessary to cut off part of the tailpiece (area “B”) or
part of the horizontal leg of the trap (area “C”). Secure joints for
watertight assembly.
Drop-In Installation:
• Place the sink temporarily into the template
• Check for alignment and clearance
• Mark the sink and countertop in several places
as a guide for the installation location.
Drill a clearance hole inside the perimeter line of the
template for drop-in installation.
Cut opening around the perimeter of the template.
Perimeter of
template
Perimeter of
template
Drop-In Installation:
Using the template provided, locate the position of the sink
on the above counter. Provide proper clearance under the
countertop for the faucet supply lines, drain assembly and
the structural parts of the cabinet.
NOTE: If replacing an existing sink be certain to shut off
water supply before removing old sink.
Mount the faucet and drain assembly (not included) on the sink
following the manufacturer’s instructions. Be certain to apply a
bead of sealing putty on the underside of the drain (if required)
(Part “A”) in order to ensure a watertight seal between the sink
and drain. Remove excess putty after installing drain on sink.
A
1
2
3
4
Shut-Off Valves
After checking fit and alignment, turn sink upside down and
apply a generous portion of silicone adhesive around the
under side of the rim near the edge. Place sink in position.
Wipe off excess adhesive.
Connect supply line to faucet (finger tight) and carefully bend
tubes to engage with the supply shut-off valves. Tighten
connections at faucet and shut-off valves for secure seal.
B
C
5
6
6
7