Installation Guide

- 2 -
1
WALL PREPARATION:
INSTALLATION PROCEDURES
Determine if the sink will be ush mounted or under countertop mounted. Next measure the actual size of the sink being
installed to determine cabinet opening dimensions and support frame location. The cabinet opening should equal
dimensions of the sink to minimize the gap between the sink apron and cabinet.
The type of sink installation being performed will determine the support frame location.
FLUSH MOUNT or UNDER COUNTERTOP INSTALLATIONS
Typical installation includes cabinet support preparation, installation of faucet and waste tting, connection of exible water supply
lines, attachment of sink to cabinet, sizing and installation of drain and water supplies.
Sink Mounting Provisions
The cabinet area beneath the sink must be reinforced to provide sufficient support. The wood support frame for the sink must
support 400 pounds (approximate weight of sink when full and garbage disposal installed).
CABINET SUPPORT PREPERATION
Important Note:
This installation assumes the use of a custom cabinet and countertop design. It is not designed for use with standard cabinet
bases or standard countertops.
791598-101
LEVEL TOP SURFACE OF SINK & COUNTERTOP
BEFORE SECURING
SINK
COUNTERTOP
HOT & COLD SUPPLIES
FRAME
BOTH SIDES
FRAME
FRONT & REAR
FLUSH MOUNT
INSTALLATION
SHOWN