Installation Guide

730555-100 Rev. C
Center bowl over cutout
and tighten screws (see 3
or 4) to secure bowl to
countertop. Remove
excess sealant from
inside lip.
NOTE: The screws
provided should be used
on countertops with a
minimum 1" thickness.
For thinner countertops,
use appropriate anchors
and fasteners.
NOTE: Do not use adhesives or adhesive sealants.
After checking fit and alignment of sink to cut out,
apply a bead of silicone adhesive to rim of sink.
A
Mount the drain assembly (not included) on the sink,
following faucet manufacturer's instructions. Be
certain to apply a bead of sealing putty on the
underside of the drain (Part "A") in order to ensure a
watertight seal between the sink and drain. Remove
excess putty after installing drain on sink.
5
6
7
B
C
Connect supply line to faucet (finger tight) and carefully bend
tubes to engage with the supply shut-off valves. Tighten
connections at faucet and shut-off valves for water tight seal.
Connect trap to drain
assembly hand tight to check
alignment. It may be
necessary to cut off part of
the tailpiece (area "B") or part
of the horizontal leg of the
trap (area "C"). Secure joints
for watertight assembly.
Install faucet (not included) and countertop (not
included) following manufacturers instructions.
Shut-Off
Valves
8
9
10
In the United States:
American Standard Brands
P.O. Box 6820
Piscataway, New Jersey 08855
Attention: Director of Consumer Affairs
For residents of the United States, warranty
information may also be obtained by calling the
following toll free number: [phone]
www.americanstandard-us.com
In Canada:
AS Canada ULC
2480 Stanfield Rd.
Mississauga, Ontario
Canada L4Y 1S2
Toll Free: [phone]
www.americanstandard.ca
In Mexico:
Customer Service Manager
AS Maquila, S.A. de C.V.
Via Morelos #330
Col. Santa Clara
Ecatepec 55540 Edo. Mexico
www.americanstandard.com.mx