Installation Instructions

- 2 -
770002-100 Rev.C
WASHSTAND INSTALLATION
Unpack unit carefully, taking care that bottom shelf does not drop and damage front legs (see Figure 2).
Provide suitable reinforcement for anchoring the washstand to the wall. Centerline of reinforcement should be 27-3/4" up
from the floor (see Figure 1).
Rough in supply lines and waste per rough-in dimensions.
The molding needs to be notched to seat the washstand flush against the wall.
Move the washstand into place and level with the adjustable glides on the bottom of the feet.
The glides can be adjusted outward up to 1" but it is recommended not to exceed 1/2" if possible.
Drill at least two 3/8" O.D. anchoring holes through the centerline of the rear stringer of the vessel stand, located 3/4"
down from the top of the table (see Figure 2).
Anchor the washstand to the wall through at least 2 of the anchoring holes in the rear of the washstand (see Figure 2).
Continue with installation appropriate for top and sink options chosen.
C/L of 2 x 6
Reinforcement
Finished
Floor
27-3/4"
(705mm)
FIGURE 1
ADJUSTABLE
LEVELLERS
(under each foot)
FINISHED
FLOOR
FINISHED
WALL
REAR STRINGER
WITH ANCHORING
HOLES TO SECURE
VANITY TO WALL
FIGURE 2
ANCHORING
HOLES
IN REAR
STRINGER
[NOT SHOWN]
33"
(838mm)
2-1/2"
(64mm)
4"
(102mm)