Specifications

AMERICAN RANGE CORPORATION
MADE IN USA
DESIGNED a BUILT
-17
INSTALLATION INSTRUCTIONS
• Do not remove protective packaging until you are ready to perform the installation.
• Do not remove the protective wrapping from the product control panel until the product is installed.
• Caution - the appliance is heavy. Use extreme care when handling!
• Use proper equipment to move products.
• Any openings in the wall and in the floor behind or under the oven must be sealed.
• Do not use an extension cord with this appliance. Such use may result in fire, electrical shock or other
personal injury.
Do not use the handle or oven door to lift the oven. Remove
pull down door before installation to ensure that it is not used
to lift the unit. Make sure the hinge catch is fully open or closed
before removing door to prevent injury to hands and/or fingers.
• Installation of this appliance should be performed by qualified, licensed contractors.
• Products are anchored to the wooden shipping pallet using metal straps that are screwed to the bottom
of the product and the pallet.
• To remove the packaging, first remove the staples located at the bottom perimeter of the corrugated
cardboard cover.
• Remove the corrugated cardboard carton by lifting it off the product and remove the inner packing.
• Detach the product from the metal anchor strip by removing the attachment screw.
• Confirm available access to adequate power and gas. See specifications & electrical requirements table.
• Fill out page 4 of this installation manual with the requested data. Model Number and S erial N umber can be
found on the plate located underneath the control panel on the front of the appliance.
WARNING