Installation Guide

American Pro Decor assumes no liability for improper installation.
Use finishing nails or screws (small head) to
fasten the beams to the wall blocking.
Screws will need to be countersunk. Nails
and screws can be covered with colored
wood filler or colored caulk.
After dry fitting and length adjustments,
apply construction adhesive to the outside of
the wood blocking and the tops of the beam.
Press firmly in place.
Dry fit each beam without adhesive and make
adjustments to the beam length if needed.
NOTE: Light sanding will help with a snug fit.
Measure each installation point prior to
cutting to account for variances in the wall.
It is recommended that the beams be cut
a little long so they fit snuggly and can be
adjusted after dry fitting.
NOTE: Our beams come with an open and
closed end. We recommend facing the
closed end towards the wall.
8.
7.
6.
5.
4.
Clean any excess adhesive and apply caulk
where the beam and wall meet if needed.