Installation Guide

ManualsBrandsAmerican Pro Decor ManualsBuilding materialsArtisan 6 in. x 6 in. x 15.67 ft. Unfinished Sand Blasted Faux Wood Beam (2-Piece x 94 in. Kit)

American Pro Decor assumes no liability for improper installation.

Measure the inside width of the beam and cut

the wood blocking to the inside width dimension.

Pre-drill at least two holes per block to make

them easier to attach.

Determine where the beam will be installed. If

installing multiple beams, determine your spacing.

Once you have determined the installation points

and spacing, mark the center point along both

sides of the wall. Connect the marks using a chalk

line or laser level.

Tools & Material List

• 2x4 Wood Blocking

(For Mounting]

• Measuring Tape

• Power Drill

• Hammer

• Saw

• Stud Finder

• Chalk Line / Laser Level

• Nails

• Screws (Small Head)

• Construction Adhesive

• Caulk Gun

• Caulking

• Painters Tape

Safety Instructions

• Make sure to use the correct tools and wear proper protective gear.

• Follow any and all instructions and user manuals provided by your ﬁxture,

power tool, and paint manufacturer.

Special Instructions & Notes

• Thoroughly read through the installation instructions to familiarize yourself

with the process prior to beginning installation.

• If studs or joist do not align with the wood blocking, it is recommended to

use molly bolts or toggle bolts to secure the wood blocking to the ceiling.

• Allow the beams to acclimate to room temperature for at least 24 hours

prior to installation.

• When lining up two beams end-to-end to create a longer beam, butt the

open ends together for the best match and cut any excess length from the

closed ends. Use the rubber beam strap provided to cover the butt joint.

Installation Instructions for Faux Wood Beams

Step-by-Step Instructions

Attach the wood blocking two feet from the wall

using your center line. Install additional blocking

every three to four feet.

Use a pencil line or painters tape to mark where

the wood blocking is installed. This will help to

identify where the wood blocks are located when

fastening the beam.

NOTE: If the studs or joints do not align with the

wood blocking, it is recommended that you use

molly bolts to secure the wood blocking.

Summary of content (4 pages)

PAGE 1
Installation Instructions for Faux Wood Beams Safety Instructions • • Make sure to use the correct tools and wear proper protective gear. Follow any and all instructions and user manuals provided by your fixture, power tool, and paint manufacturer. Special Instructions & Notes • • • • Thoroughly read through the installation instructions to familiarize yourself with the process prior to beginning installation.
PAGE 2
4. Measure each installation point prior to cutting to account for variances in the wall. It is recommended that the beams be cut a little long so they fit snuggly and can be adjusted after dry fitting. NOTE: Our beams come with an open and closed end. We recommend facing the closed end towards the wall. 5. Dry fit each beam without adhesive and make adjustments to the beam length if needed. NOTE: Light sanding will help with a snug fit. 6.
PAGE 3
Installation Instructions for Flexible Beam Straps 1. 2. Draw a light pencil line perpendicular to the center of the beam strap. 3. Lay the strap along the beam. Make sure that the straps three bolt heads are even on the top of the beam. Use a pencil to mark your trim line and cut the strap along the trim line with scissors to fit to the beam. 4. Apply a bead of adhesive to the back of the strap.
PAGE 4
Installation Instructions for Suspended Beams - Wall-to-Wall 1. 2. Clean the wall and locate the studs in the wall. 4. 3. Use screws to fasten a joist hanger to the wall 5. The beam has to fit perfectly, if not, you will need to fill the extra space with wood. Measure the negative space. This will show you how thick it has to be. Lightly push the lumber into the joist hanger. This structure will support your beam. Secure the lumber with screws. 6. Screw wood blocks on the support structure. 7.