BYPASSING HARDWARE KIT FOR SLIDING DOUBLE WOOD DOORS MODEL No. INSTALLATION MANUAL 5APD10915 A B F C D O M GH I N J E K L INCLUDED IN KIT A B C D E Door Roller Hardware x4 M8x60 Bolt x9 M8x30 Wall Anchor x9 Wall Bracket x10 68-7/8" Rail x2 F G H I J ST8x90 Bolt + Washer x9 Routed Floor Guide x2 Floor Anchor x4 ST4.2x25 Screw x4 Door Stop x4 K L M N O 2.
TOOLS REQUIRED NOTES • Plumb Line • Pencil • Phillips Head Screwdriver • 8mm Drill Bit • 5.5mm Drill Bit To obtain maximum weight capacity, all fasteners must be mounted into solid wood studs or wall blocking or mounted to a header board. Consult a structural engineer if you have questions about what type of wall blocking is required. American Pro Decor assumes no liability for improper installation.
Wall Blocking Find the centerline of the track. Using a level, mark a horizontal line twice the door width long. Mark the bracket screw locations into the wall blocking. Attach the wall portion of the brackets as shown. Insert the door stops to the rail. One at each end, then attach the rail to the wall brackets using a wrench to fasten the bolts as shown. Drill out holes in the doors using a 10mm routing drill bit as pictured.
Attach the anti-jump disks to the tops of the door. Attach the door to the rails making sure that the anti-jump disks are engaged to avoid a serious accident. Use a wrench to attach the bypassing brackets to the wall and rail as pictured. Insert the door stops to the rail. One at each end and attach the second rail to the bypassing brackets as shown. American Pro Decor assumes no liability for improper installation.
Attach the door to the rails making sure that the anti-jump disks are engaged to avoid a serious accident. Plumb the door and mark the positions of the floor guides. Mount the floor guides to the floor. Adjust the door stops accordingly using the provide 2.5mm Allen key. American Pro Decor assumes no liability for improper installation.
Install the end cap covers. American Pro Decor assumes no liability for improper installation.
