Installation Guide

ManualsBrandsAmerican Pro Decor ManualsBarn Door HardwareStainless Steel Sliding Rolling Barn Door Hardware Kit for Single Wood Doors With Non-Routed Adjustable Floor Guides

• Plumb Line

• Pencil

• Phillips Head Screwdriver

• 8mm Routing Drill Bit

• 10mm Drill Bit

• 5.5mm Drill Bit

• Level

• Tape Measure

• Power Drill

C D E

F G H I

78-3/4" Rail x1

Door Roller Hardware x2

End Bracket x2

Center Bracket x2

ST4.8x50 Bolt x4

ST5.5x32 Screw x3

Floor Anchor x3

Optional Routed Floor Guide x1

Door Stop x2

Non-Routed Floor Guide Set x1

4mm/6mm Allen Keys x1

MODEL No.

5APD10672

American Pro Decor assumes no liability for improper installation.

INSTALLATION MANUAL

TOOLS REQUIRED INCLUDED IN KIT

HARDWARE KIT

FOR SLIDING SINGLE WOOD DOORS

304 Grade Stainless Steel

Summary of content (4 pages)

PAGE 1
HARDWARE KIT FOR SLIDING SINGLE WOOD DOORS 304 Grade Stainless Steel MODEL No. INSTALLATION MANUAL 5APD10672 A C D E B F G H J TOOLS REQUIRED I K INCLUDED IN KIT A B C D • Plumb Line • Pencil • Phillips Head Screwdriver • 8mm Routing Drill Bit • 10mm Drill Bit • 5.5mm Drill Bit • Level • Tape Measure • Power Drill E F G H I J K 78-3/4" Rail x1 Door Roller Hardware x2 End Bracket x2 Center Bracket x2 ST4.8x50 Bolt x4 ST5.
PAGE 2
NOTES Minimum door overlap on guide is 1-15/16" To obtain maximum weight capacity, all fasteners must be mounted into solid wood studs or wall blocking or mounted to a header board. Consult a structural engineer if you have questions about what type of wall blocking is required. Find the centerline of the track. Using a level, mark a horizontal line twice the door width long. Mark the bracket screw locations into the wall blocking. Attach the wall portion of the brackets as shown.
PAGE 3
1. Remove the anti-rise pin from the door roller using the provided 4mm Allen key. 2. Drill holes centered in the door thickness for the door roller anchors using an 8mm routing drill bit. Attach the door to the rail. Plumb the door and mark the positions of the floor guides. Mount the floor guides to the floor. American Pro Decor assumes no liability for improper installation.
PAGE 4
Adjust the door stops accordingly. Tighten the set screw with sufficient force to drive the set screw into the bar after making the final adjustment. Reattach the anti-rise pin to the door rollers American Pro Decor assumes no liability for improper installation.