INSTRUCTION 6X6M PARTY TENT Part no. Item Drawing Quantity 1 Rafter Poles (Length 57.87") 16 2 Cross Poles (Length 76.38") 15 3 Leg poles (Length 75.59") 8 4 Roof reinforce (Length 59") 8 5 Roof reinforce (Length 19.
14 Wing Nut 16 15 Screw 70 16 Short Bungees 26 17 Long Bungees 92 18 Guy Line 4 19 Spiral Peg 4 20 Thick Peg Ø6x180mm 8 21 Thin Peg Ø4x180mm 36 22 Hook 8 23 Roof 1 24 Side Panel 6 25 End Panel 2 Before putting up Please use gloves when assembling the metal frame portion of this unit. The metal components of this product have been treated with a rust preventive coating that may feel oily to the touch.
a mixture of warm water and dish detergent prior to assembly. Should your hands become dirty, simply wash with soap and water. Pay attention to the following points when choosing a location: • The pavilion must stand on a flat, non-slip and safe place • choose a sheltered location • Avoid damage to the material, please place the pavilion so that it cannot rub or chafe on branches, parts of buildings etc.
Step 2. Connect the roof poles and connectors from middle and out. To ensure the screws (#15) fixed to every pole tightly. Tips: Make sure all the poles are pushed all the way into the connectors and all screws are tightened. IF the poles are not pushed all the way to the connectors, the frame that you build will be bigger than the top size. Canopy cover won’t fit the frame. Step 3: Apply the reinforce bars #4 and #5 as shown.
to fasten the bars #4 and #5. Step 5: Insert leg poles ( #3) into one side as shown below and put the roof cover on the frame. Step 6: Lift the opposite site of the frame and insert remaining leg poles (#3) to finish the tent framework. And tie down with bungee balls as shown.Take care of the tension of the long bungee balls ,for if you use too many on one side of tent ,it may too tight to tie the other side of it .
finished. Step 7: Attach the side panels and end panels by bungees as picture show below Step 8: Use the thick pegs to secure the legs to the ground. Use the hooks to secure the leg cover to the leg poles.
Step 9. The guy lines clasp to each corner of tent and another end of line secure to the ground by spiral pegs. Use the thin pegs to secure the side and end panels to the ground This is a temporary spike anchor. Not intended for permanent use. Warning: You must use stakes to secure your tent to the ground. If you set up your tent on concrete, you need to buy sand bags, water bucket, or bolts to secure your tent. Any shelter that is not anchored securely has the potential to fly away causing damage.
All images used are for illustration purposes only and may not represent an individual product. Note: PROPER ANCHORING OF THE FRAME IS THE RESPONSIBILITY OF THE CONSUMER. Choose proper anchor system FOR YOUR NEEDS. Heavy duty anchors, such as storm straps and ground pegs, are sold separately and are not included in this product.
