Specifications

BXT7059 / BXTS7059Technical Reference Boot Setup
Chapter 4 Boot Setup
Introduction
Select the Boot Setup menu item from the Aptio TSE screen to enter the BIOS Setup screen. The Boot
menu option allows you to access the following the following boot setup features.
Boot Configuration
Enter the number of seconds you wish the board to wait for a setup key activation key.
Option
Description
Setup Prompt
Timeout
Acceptable values: 0 to 65535 (0xFFFF) and the default value is 1
Note: 65535 means the BIOS will wait indefinitely for a key press
Bootup
Numlock State
On/Off – Selects the keyboard numlock state
Quite Boot
Disabled/Enabled - this default value allows the computer system to display the POST
messages. The enabled option is used for displaying a custom OEM logo during
POST.
Fast Boot
Disabled/Enabled – this default setting allows the computer system to perform a full
boot with a full set of devices. In full configuration mode, all devices are detected and
initialized. The enabled option allows the computer system to do a minimal boot. In
minimal configuration mode, only the devices that are necessary to boot the system are
detected and initialized as defined in the option settings below:
VGA Support: Auto/EFI Driver
USB Support: Disabled/Full Initial/Partial Initial
PS2 Support: Disabled/ Enabled
Network Stack Driver Support: Disabled/ Enabled
Boot Option Priorities
The following settings allow you to set the system boot priority of where to pull the BIOS settings from in
order to perform a system boot. You can set four priority levels and the number of available options within
each priority is based on the devices connected to the SHB. Here is an example of potential boot options.
Option
Description
Boot Option
Priorities
Boot Option #1: IBA GE Slot 00C8 v1395, IBA GE Slot 0900 v1395, IBA GE Slot
0901 v1395, UEFI: Built-In EFI Shell, Disabled
Boot Option #2: IBA GE Slot 00C8 v1395, IBA GE Slot 0900 v1395, IBA GE Slot
0901 v1395, UEFI: Built-In EFI Shell, Disabled
Boot Option #1: IBA GE Slot 00C8 v1395, IBA GE Slot 0900 v1395, IBA GE Slot
0901 v1395, UEFI: Built-In EFI Shell, Disabled
Boot Option #1: IBA GE Slot 00C8 v1395, IBA GE Slot 0900 v1395, IBA GE Slot
0901 v1395, UEFI: Built-In EFI Shell, Disabled
Any other devices connected to SHB and the system would show up under each option in the above listing.
Other possible boot option devices are: SATA Hard Drive [HD type info], and USB Flash Hub [USB type
info].
CSM16 Parameters
These are special purpose BIOS settings and should remain in the default positions.
Option
Description
CSM16
Parameters
Gate20 Active: Upon Request, Always
Option ROM Messages: Force BIOS, Keep Current
INT19 Trap Response: Intermediate, Postponed
4-1 Trenton Systems Inc.