Specifications

Advanced Setup BXT7059 / BXTS7059 Technical Reference
Thermal Configuration
This is sub-menu is an enable/disable selection for initializing the Intel® C604 thermal subsystem device.
Option
Description
Thermal
Management
Disabled/Enabled -- If thermal management is enabled, the ME SMBus
Thermal Reporting (Disabled/Enabled) selection becomes active and if enabled
the following set-up parameters become visible:
PCH Temp Read: Disabled, Enabled
CPU Energy Temp Read: Disabled, Enabled
CPU Temp Read: Disabled, Enabled
Alert Enable Lock: Disabled, Enabled (if enabled, the following selections
become visible)
PCH Alert: Disabled, Enabled
DIMM Alert: Disabled, Enabled
Intel® TXT (LT-SX) Configuration
Currently these BIOS parameters are fixed and the configuration states are listed on the TXT sub-menu.
USB Configuration
The top portion of the menu screen lists the USB devices detected by the BIOS. The lower portion has
several sub-menu selections available where you can set the parameters for the USB devices.
Option
Description
USB Devices:
1 Keyboard, 2 Hubs – Status message that is variable based on the USB devices
connected to the system and read by the BIOS on boot-up
Legacy USB Support Enabled/Disabled/Auto
USB3.0 Support Enabled/Disabled
XHCI Hand-Off Enabled/Disabled
EHCI Hand-Off Disabled/Enabled
USB Mass Storage
Driver Support
Enabled/Disabled
Port 60/64 Emulation Disabled/Enabled
USB Hardware
Delays and Timeouts
The following sub-menu selections are used to configure data transfer delays
and timeouts needed for the USB storage devices used in the system design:
USB Transfer Timeout: 1 sec, 5 sec, 10 sec, 20sec
Device Reset Timeout: 10sec, 20sec, 30sec, 40sec
Device Power-Up Delay: Auto, Manual (if manual, the following becomes
visible)
Device Power-Up Delay in Seconds: 1 is the default value, 5 is the optimal
value, other values may be entered
Super IO Configuration
The only Super IO component available in a system implementation using a BXT7059 or BXTS7059 is
located on the optional IOB33 module. An IOB33 can plug into the SHBs’ P20 I/O Expansion connector.
When an IOB33 is plugged into the SHB, the Super IO Configuration set-up parameters will be displayed.
This Advanced Setup sub-menu allows you to configure the system ports connected to the IOB33s’ Super
I/O component.
NOTE: The following Super IO settings are only valid when an optional Trenton IOB33 I/O Board is
installed on the BXT7059 or BXTS7059 SHB.
Trenton Systems Inc. 2-6