Specifications

BXT7059 / BXTS7059 Technical Reference Advanced Setup
Runtime Error Logging Configuration
Use this menu selection to enable or disable the runtime error logging support feature.
Option
Description
Runtime Error
Logging
Disabled/Enabled (bold = default setting) - If enabled the following sub-menu
option choices are available:
Memory Correctable Error Threshold Value: 10, 11, 12, 13, 14, 15
PCI Error Logging Support: Disabled/Enabled
Poison Support: Disabled [fixed setting]
Short operational descriptions for each sub-menu setting can be found in the
upper left corner of the BIOS set-up screen.
SATA Configuration
This is where you can set the parameters for the SATA devices that have been sensed by the SHB during
the boot process. SATA devices connected to ports P27 or P28 on the SHB may operate at data transfer
rate up to 600MB/s. SATA devices connected to P31, P32, P35 or P36 have a maximum data transfer rate
of 300MB/s. What follows is a list of SATA port configuration parameters.
Option
Description
SATA Mode
Disabled/IDE Mode/AHCI Mode/RAID (bold = default setting) - Short
operational descriptions for each sub-menu setting can be found in the upper left
corner of the BIOS set-up screen.
Serial-ATA
Controller 0
Disabled/Enhanced/Compatible
Serial-ATA
Controller 1
Disabled/Enhanced
Serial-ATA
Controller 2
Disabled/Enhanced (Note: This is the SATA controller for the SATA interface
routed to the backplane via board edge connector C)
Aggressive Link
Power Management
Disabled/Enabled
Port 0 through 2 Hot
Plug
Disabled/Enabled
External SATA Port
0 through 2
Disabled/Enabled
Staggered Spin Up
Disabled/Enabled – There are three of these option selections available.
If the SATA Mode selection is changed to RAID then the following sub-menu options are available:
Option
Description
Port 0 through 2 Hot
Plug
Disabled/Enabled
SAS Configuration
SHB ports P31, P32, P36 or P36 also support SAS devices. This sub-menu selection is where you
configure the system for SAS drives if there are SAS devices connected and sensed by the SHB during the
boot process.
Option
Description
SAS Port # [0 – 7]
Not Present/Disabled/Enabled
2-5 Trenton Systems Inc.