User`s guide

32 KTC5520/EATX

www.kontron.com

5. Software Setup

5.1 AMI BIOS Setup Program

All relevant information for operating the board and connected peripherals are stored in the CMOS memory

backed-up by a battery or in the main BIOS flash and EEPROM. The latest is the default configuration.

5.1.1 Accessing the BIOS Setup Utility

The system BIOS (Basic Input Output System) provides an interface between the operating system and the

hardware of the KTC5520/EATX board. It uses the AMI Setup program, a setup utility in flash memory that is

accessed by pressing the <DEL> (or <F4> from a console redirection terminal) key at the appropriate time

during system boot. This utility is used to set configuration data in CMOS RAM.

To run the AMI Setup program incorporated in the ROM BIOS:

• Turn on or reboot the system.

• When you get the following messages, hit <DEL> key to enter SETUP.

KONTRON KTC5520/EATX BIOS Version 1.28

64-3047-009999-00101111-112408-TYLSBURG-5007_041-Y2KC

CPU : Intel(R) Xeon(R) CPU E5540 @ 2.53GHz

Speed : 2.53 GHz

Reset Type: Cold Reset

BIOS Upgrade externally

Currently Running On Primary BIOS.

Press DEL to run Setup (F4 on Remote Keyboard)

Press F12 if you want to boot from the network

Press F11 for BBS POPUP (F3 on Remote Keyboard)

Initializing USB Controllers .. Done.

Memory Channel 0 DIMM 0 Size 1024MB

Memory Channel 0 DIMM 1 Size Not Installed

Memory Channel 1 DIMM 0 Size Not Installed

Memory Channel 1 DIMM 1 Size Not Installed

Memory Channel 2 DIMM 0 Size Not Installed

Memory Channel 2 DIMM 1 Size Not Installed

DDR3: 1016MB OK, Speed: 1333MHz

USB Device(s): 1 Keyboard, 1 Storage Device

Auto-detecting USB Mass Storage Devices ..

Device #01 : Corsair Flash Voyager *HiSpeed*

01 USB mass storage devices found and configured.

Initializing Intel(R) Boot Agent GE v1.3.24

PXE 2.1 Build 086 (WfM 2.0)

Initializing Intel(R) Boot Agent GE v1.3.24

PXE 2.1 Build 086 (WfM 2.0)