User`s guide

Chapter Two : Quick Installation
7
Installation
Text Mode
Use the following steps to install the StorTrends NAS software into the StorTrends 2104
server in Text Mode.
Step Action
1 Power down your StorTrends 2104 server. Verify that your StorTrends 2104 server meets the minimum
system requirements to install the StorTrends NAS Software.
z any Intel® Pentium® 4 processor or Intel® Celeron 478-pin FCPGA processor can be installed into
your StorTrends 2104 server
z a 101/104 keyboard (PS/2 or USB)
z a VGA monitor that supports a screen resolution of 640 x 480 or greater
z a USB CD-ROM drive
z at least 512 MB of system memory
z at least 1 GB of hard disk drive space
Note: You can also opt to use an IDE CD-ROM drive. Attach the CD-ROM drive to the IDE
connector on the hard disk drive tray in the third bay from the left. If you try to load from any
other bay, the installation can fail.
2 Power on your StorTrends 2104 server and insert the StorTrends NAS Software (Version 2.2) CD. Allow
your StorTrends 2104 server to boot up off the StorTrends NAS Software CD.
Note: The system BIOS must be set to boot from the CD-ROM first.
3 After your StorTrends 2104 server boots up, you are prompted to install the StorTrends NAS Software.
Press the <ENTER> key to begin the installation.
 ToinstallStorTrendsNASSoftware,
 pressthe<ENTER>key.
boot:_
Cont’d