User manual

PCE-5125 User Manual 18
2.1 Introduction
You can access most of the connectors from the top of the board as it is being
installed in the chassis. If you have a number of cards installed, you may need to par-
tially remove the card to make all the connections.
2.2 Floppy Drive Connector (FDD1)
You can attach up to two floppy disk drives to the PCE-5125's onboard controller. You
can use 3.5" (720 KB, 1.44 MB) drives.
On the end of the cable is a 34-pin flat-cable connector. On the other end are two
sets of 34-pin flat-cable connectors (usually used for 3.5" drives). The set on the end
(after the twist in the cable) connects to the A: floppy drive. The set in the middle con-
nects to the B: floppy drive.