User`s guide

Chapter 1 Hardware Installation
25
Step 9 Connect I/O, Continued
JP9 Floppy JP9 is a 34-pin dual-inline berg. Connect the cable from
the floppy drive to JP9, as shown below. The onboard
floppy controller cannot be used if a hard disk card with a
floppy controller is installed. Choose Standard Setup and
Peripheral Setup to configure the floppy controller.
The motherboard supports up to two 720 KB, 1.44 MB, or
2.88 MB 3½" drives and 360 KB and 1.2 MB 5¼" drives.
The connecting cable is a 34-pin ribbon connector with
two 34-pin edge connectors for attaching the floppy disk
drives. There is a small twist in the cable between the
floppy connectors. The last (end) connector should be
connected to floppy drive A: as shown below.
Title: FLOOP.EPS from CorelDRAW!
Creator: CorelDRAW!
CreationDate: Tue Jun 06 17:57:03 1995
Cont’d