User`s guide

MegaRUM II PCI Motherboard User’s Guide
18
Step 8 Attach Cables, Continued
JP11 Drain CMOS RAM Power JP11 is a 3-pin berg that can be used to
erase the contents of CMOS RAM, where all system
configuration information is stored.
If you forget the AMIBIOS password, you can place a
shorting bridge on JP11 for a few seconds to erase the old
password (and all system configuration information as
well). You must then reboot the computer, run AMIBIOS
Setup, and restore all system configuration information.
The JP11 settings are:
CMOS Drain JP Setting
Normal operation (factory setting). 1-2
The contents of CMOS RAM are destroyed. 2-3
JP3 Infrared Connector The JP3 is a 10-pin dual-inline berg.
Pin Assignments
1 VCC5V
2, 6, 7, 8, 9, 10 N/C
3
4
5
IRRX
GND
IRTX
Cont’d