User`s guide

MegaRUM II PCI Motherboard User’s Guide
14
Step 7 Install the Motherboard
Step Action
1 Place the chassis on an anti-static mat. Connect the chassis to ground
to avoid static damage during installation. Connect an alligator clip
with a wire lead to any unpainted part of the chassis. Ground the other
end of the lead at the same point as the mat and the wristband.
2 Rotate the chassis so the front is to the right, and the rear is to the left.
The side facing you is where the motherboard is mounted. The power
supply is mounted at the far end of the chassis.
3 Hold the motherboard, component-side up, with the edge with the
SIMM sockets toward you and the edge with the power supply
connector away from you. The keyboard, mouse, and video connectors
should be to the left.
4 Carefully slide the motherboard into the chassis. Make certain the edge
connectors fit the ports in the rear of the chassis. The motherboard
should rest level with the chassis.
5 Place the mounting screws in the holes provided and tighten them. If
necessary, shift the motherboard slightly to align the mounting holes on
the motherboard with the holes on the chassis,
Warning
If using metallic screws, make sure you use them only in
the plated mounting holes.
If using metallic screws, make sure the head of the screw
fits completely inside the plated mounting holes.