User`s manual

BIOS SETUP
MB966 User’s Manual 33
BIOS SETUP UTILITY
Main Advanced PCIPnP Boot Security Chipset Exit
PCI Express Configuration
Enable/Disable
PCI Express L0s and
L1 link power states
<- Select Screen
↑↓ Select Item
+- Change Field
Tab Select Field
F1 General Help
F10 Save and Exit
ESC Exit
Active State Power Management [Disabled]
BIOS SETUP UTILITY
Main Advanced PCIPnP Boot Security Chipset Exit
Configure Remote Access type and parameters
Select Remote Access
type.
<- Select Screen
↑↓ Select Item
+- Change Field
Tab Select Field
F1 General Help
F10 Save and Exit
ESC Exit
Remote Access Enabled
Serial port number [COM1]
Base Address, IRQ [3F8h, 4]
Serial Port Mode [1115200 8,n,1]
Flow Control [None]
Redirection After BIOS POST Always
Terminal Type ANSI
VT-UTF8 Combo Key Support Enabled
Sredir Memory Display Delay No Delay
When enabled, the Remote Acces type and parameters are shown:
Serial port number - Select Serial Port for console redirection.
Serial port mode - Select Serial Port settings.
Flow Control - Select Flow Control for console redirection.
Redirection After BIOS POST
Disable: Turns off the redirection after POST.
Boot Loader: Redirection is active during POST and during Boot Loader.
Always: Redirection is always active. (Some OSs may not work if set to
Always.)
Terminal Type - Select the target terminal type.
VT-UTF8 Combo Key Support – Enable VT-UTF8 Combination Key
Support for ANSI/VT100 terminals.
Sredir Memory Display Delay – Gives the delay in seconds to display
memory information.