User manual

IMB-Q670 Micro-ATX Motherboard
Page 60
Step 1: Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 2: Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the on-board SATA drive
connector. See Figure 4-13.
Figure 4-13: SATA Drive Cable Connection
Step 3: Connect the cable to the SATA disk. Connect the connector on the other end
of the cable to the connector at the back of the SATA drive. See Figure 4-14.
Step 4: Conn
ect the SATA power cable (optional). Connect the SATA power
connector to the back of the SATA drive. See Figure 4-14. Step 0: