User manual

ICE-QM871 COM Express Module
Page 141
C.1 Intel
®
AMT Setup Procedure
The ICE-QM871 is featured with the Intel® Active Management Technology (AMT) 2.5. To
enable the Intel® AMT function, follow the steps below.
Step 1: Make sure the SO-DIMM socket is installed with one DDR2 DIMM.
Step 2: Connect an Ethernet cable to the RJ-45 connector on the baseboard.
Step 3: The AMI BIOS option regarding the Intel® AMT must be enabled:
Intel® AMT Configuration [Advanced]
Step 4: Configure the Intel® Management Engine BIOS extension (MEBx) (see
Section
C.2 below)
Step 5: Properly install the Intel® AMT drivers. Make sure to install both HECI and
LMS_SOL drivers from the iAMT Driver & Utility directory in the driver CD.
Step 6: The following dialog window is displayed after the OS is loaded to show the
Intel® AMT status on the ICE-QM871 is enabled.Step 0:
Figure C-1: Intel® Active Management Technology Status Dialog
C.2 Intel
®
Management Engine BIOS Extension
This section describes the essential steps for using the Intel® Management Engine BIOS
extension (MEBx).
Step 1: A screen prompts the user to press <Ctrl+P> after a single beep during boot-up
process. To get into the Intel® MEBx settings, press <Ctrl+P>.