User guide

 6-3
6.1.3 Setting the RAID item in BIOS

from SATA hard disk drives attached to the SATA connectors supported by
Intel
®
. To do this:
 
 
Advanced
Menu >

, then press <Enter>.
3. Set
SATA Mode

 

Setup.
 
Depending on the RAID connectors that you use, you can create a RAID set using
the utilities embedded in each RAID controller
. For example, use the
LSI Logic
Embedded SATA RAID Setup Utility
or the
Intel
®
Rapid Storage Technology
if
you installed Serial ATA hard disk drives on the Serial ATA connectors supported by
the Intel
®


utility.
6.1.2 Installing hard disk drives

performance, install identical drives of the same model and capacity whe
n creating
a disk array.

1. Install the SATA hard disks into the drive bays following the instructions in the
system user guide.
 
and to the SATA connector on the motherboard.
3. Connect a SATA power cable to the power connector on each drive.