User manual

Chapter 4 Install the Drivers
- 22 - CPC-3713CLD3N
 IDE Configuration
BIOS SETUP UTILITY
IDE Configuration
ATA/IDE Configuration [Enhanced]
Configure SATA as [IDE]
Primary IDE Master
:[Not Detected]
Primary IDE Slave
:[Not Detected]
Secondary IDE Master
:[Not Detected]
Secondary IDE Slave
:[Not Detected]
Third IDE Master
:[Not Detected]
Third IDE Slave
:[Not Detected]
←→ Select Screen
↑↓ Select Item
+ - Change Field
Tab Select Field
F1 General Help
F10 Save and Exit
ESC Exit
V02.61 (c)Copyright 1985-2006, American Megatrends, Inc.
 ATA/IDE Configuration
This option is used to configure the operating mode for ATA; there are two
options: Enhanced mode and Compatible mode.
 Configure SATA as
SATA controller type selection; there are three options for this item: IDE, RAID
and AHCI. Only when ATA/IDE Configuration is under Enhanced mode, are
RAID and AHCI supported.
Both RAID and AHCI functions require supports from hardware chip and OS.
Note: RAID is supported on ICH8M-E only.
 Legacy IDE Channels
Configure the IDE channel type under compatible mode; there are four options:
SATA Only, SATA Pri, PATA Sec and PATA Only.
 Primary ~ Third IDE Master/Slave
﹡Type
Not Installed: no IDE device can be detected by system;
AUTO: automatic detection of IDE parameters when powering on;
CD/DVD: used for ATAPI CDROM;