User manual

Chapter 2 Installation
- 10 - CPC-3713CLD3N
5. The board provides one reset button (SW1).
Indicator
LED Status Description
OFF HDD or CF card is idle
HDD
ON HDD or CF card is operating
OFF Power failure
PWR
ON Power normal
OFF Normal operation status
HS
ON Under hot swap status
OFF Watchdog is not operating
D8/D10
WDT
ON Watchdog is operating
LAN indicators on rear IO, CPC-RP3713-T (No LAN indicators on
CPC-3713CLD3N)
LED Description
LAN1 LINK
LAN indicator for LAN1 on rear IO,
CPC-RP3713-T
LAN1 ACT
LAN indicator for LAN1 on rear IO,
CPC-RP3713-T
LAN2 LINK
LAN indicator for LAN2 on rear IO,
CPC-RP3713-T
D5/D6
LAN2 ACT
LAN indicator for LAN2 on rear IO,
CPC-RP3713-T
LCD Backlight Control Connector
The board provides one 1 x 4Pin LCD backlight control connector (Pitch: 2.54mm);
the pin definitions are as follows:
Pin Signal Name
1 VCC_LCDBKLT
2 NC
3 LCD_BKLTEN
LCDB1
4 GND
VCC_LCDBKLT---Backlight Power (The current is limited below 1A);
LCD_BKLTEN ---Backlight Enable, Active High (The signal is output as CMOS via
North Bridge directly; the voltage amplitude is between 0V-3.3V).