User`s manual

46 CPC-2347 User's Manual
Standby mode
This sets the period of system inactivity after which the system
goes into Standby mode, the intermediate power saving state.
The settings range from 2 minutes to 16 minutes and can be set
manually when power management is Enable. The default setting
is Disabled. When the system goes into power saving mode, power
management will skip to the next mode in the sequence if this is
disabled.
3.8 PnP/PCI configuration setup
Figure 3-7: PCI configuration screen
Resources Control
When you choose Resources Control by Auto(ESCD), BIOS can
automatically configure all the boot and plug and play compatible
devices. IRQ, DMA and Memory resources will be unable to be
changed.
When you choose Resources Control by Manual, IRQ, DMA, and
Memory resource can be set up manually.