Specifications

SL 486VE User's Manual
5.6.2 View Switch/Jumper Settings
After saving the configuration, it is important that you do the following steps
before using this system:
1. Note the switch and jumper settings and verify that all switches
and jumpers on the boards in your systems set correctly. Some
boards have switches and jumpers that need to be set manually.
2. Note the software statements to see if any of the boards in your con-
figuration need special drivers to be loaded.
5.7 Define ISA Board
Most ISA adapter cards do not have a CFG file. Without a CFG file, the
ECU cannot reserve system resources automatically for ISA adapter cards.
These cards must be configured manually.
The chart below lists the resources used by common ISA adapter cards and
helps avoid assigning one of these resources to an EISA adapter card.
Type of ISA Adapter Card !RQ
DMA
Ports
I Floppy Disk Controller:
6
2
3F0h-3F7h
'j Serial Ports: СОМ1:
COM2:
COM3:
COM4:
4
3
4
3
-
3F8h-3FFh
3F8h-2FFh
3E8h-3EFh
2E8h-
2EFh
| Parallel Ports:
LPT1:
LPT2:
7
5
-
378h-37Fh
278h-27Fh
Other:
Other:
4-12