Specifications

SL 486VE User's Manual
5.3 Installing the ECU
The ECU is easy to install and can be used from either a hard disk drive or
a floppy drive.
Hard Disk Drive Operation
Simply copy all files from the ECU floppy disk to the same directory on the
hard disk drive. Make sure all CFG files are copied to the same directory.
Floppy Drive
You can execute the ECU from a floppy drive.
Make a backup copy of the AMI ECU floppy disk to use as a working copy.
You may have to run the ECU from a floppy drive if the system hard disk
drive must be configured by the ECU before it can be used.
System Requirements
The following are the minimum hardware and software requirements neces-
sary to successfully use the ECU:
• MS-DOS Version 3.2 or later
. 640 KB of RAM Memory
• 1.2 MB Floppy disk Drive and a hard disk drive, monitor and key-
board.
EISA Configuration Files
The ECU floppy disk should contain the following files:
. CFG .EXE the ECU (EISA Configuration Utility)
. EISACFG.HLP ECU Help file
• Several CFG files for ECS products.
Additional file can be created as the ECU is executed.
• the CFG .ISA file is created when any ISA adapter card is config-
ured
о .CMS files are created in the EISA configuration process, as are
.INF files.
4-4